JMRI Tools which support LocoNet Devices
JMRI software can provide a variety of tools to support hardware connected to the LocoNet bus. These tools provide a variety of features, such as monitoring status, reading and writing configuration. Each of the tools provides a set of features which is appropriate to the type of device it supports, as summarized in the table below.
In the table, each tool name is a link to a tool-specific help page.
| Tool | Monitor Status | Control | Configure | Download Firmware | Download Sound Project | Applies To |
| Monitor LocoNet | • | All LocoNet Traffic | ||||
| Monitor Slots | • | (limited) | Command Station's "Slots" | |||
| Monitor Clock | • | • | • | LocoNet Fast Clock | ||
| Monitor LocoNet Stats | • | PR3, LocoBuffer, LocoBuffer-II, LocoBuffer-USB | ||||
| Configure BDL16x | • | BDL16, BDL162, BDL168 | ||||
| Configure DS64 | • | DS64 | ||||
| Configure PM4x | • | PM4, PM42 | ||||
| Configure SE8C | • | SE8C | ||||
| Configure LocoIO | • | LocoIo, LocoServo, LocoBooster | ||||
| Configure Command Station | • | DB150, DCS100, DCS50, DCS51 | ||||
| Configure LocoNet ID | • | UR90, UR91(Infrared & Simplex), UR92(Infrared) | ||||
| Configure Duplex Group | (limited) | • | UR92(Duplex) | |||
| Send Throttle Message | (limited) | DT400, DT402 | ||||
| Send LocoNet Packet | &bull | LocoNet Traffic | ||||
| Select PR3 Mode | (limited) | PR3 | ||||
| Download Firmware | • | Digitrax hardware supporting Firmware upgrades | ||||
| Download Sounds | • | Digitrax Mobile Sound Decoders |